고객님의 기기용 VPN이 필요하신가요?지금 ExpressVPN에 가입하세요
ExpressVPN 계정 하나로 모든 기기에서 이용무료로 앱 이용하기
This tutorial will show you how to set up a VPN on your Synology using L2TP/IPsec. Before setting up ExpressVPN for your Synology, you will need to set up your Synology and turn off IPv6.
Not all ExpressVPN locations may be available for manually configured connections.
1. Find your ExpressVPN account credentials
Go to the ExpressVPN setup page. If prompted, enter your ExpressVPN credentials and click Sign In.
Enter the verification code that is sent to your email.
On the right, select L2TP/IPsec.
This will show you your username, password, and a list of server addresses around the world.
Keep this browser window open. You will need this information for the setup later.
2. Turn off IPv6 on your Synology
Turning off IPv6 helps prevent IPv6 traffic from leaking outside of the VPN tunnel.
To turn off IPv6, go to Control Panel > Network.
Click Network Interface > LAN. Click Edit.
In the Edit menu, click IPv6. For IPv6 setup, select Off.
Click OK. Next, reboot your Synology.
3. Create a new VPN profile
To add a new VPN profile, go to Control Panel > Network > Network Interface.
Click Create > Create VPN Profile.
On the VPN Connection Method screen, select L2TP/IPsec.
On the General Settings screen, enter the following:
- Profile name: Enter a name that will help you recognize your VPN connection. For example: ExpressVPN_NY.
- Server address: Enter the server address you found earlier.
- User name: Enter the username you found earlier.
- Password: Enter the password you found earlier.
- Pre-shared key: Enter 12345678.
On the Advanced Settings screen, select the following:
- Authentication: Select MS CHAP v2.
Check the boxes for the following options:
- Use default gateway on remote network
- Server is behind NAT device
- Reconnect when the VPN connection is lost
4. Connect to a VPN server location
You will now see your new VPN profile in the Network Interface window. Select the new VPN Profile you created, then click Connect.
When the VPN is connected, you will see the word “Connected” under your profile name.
Disconnect from a VPN server location
To disconnect from the VPN server, go to Control Panel > Network > Network Interface. Click the VPN profile, then click Disconnect.