För att använda våra appar och konfigurationer behöver du först skaffa ett ExpressVPN-konto.
This guide will show you how to restore the original firmware of a router running ExpressVPN. Before you start, make sure to download the router’s original firmware on the official Asus, Linksys, or Netgear websites, or for Aircove from the ExpressVPN setup page.
Restore the original firmware of a router running ExpressVPN (v2 onwards)
- Sign in to your router running ExpressVPN.
- Select Advanced Settings > Software Update.
- Select Choose File.
- Select the router’s original firmware file you downloaded. Select Update Now.
- Your router will take some time to update its firmware. During this process, your devices will be disconnected from the router’s network.
- Connect to the router’s network using a LAN cable or Wi-Fi.
- Access your router’s default gateway to check if you restored its original firmware successfully.
Note: For ExpressVPN Aircove, restoring the firmware is the same as reinstalling it. It can be a useful fix if the Aircove is not working properly.
“Invalid file. Upload again.”
If you see the “Invalid file. Upload again” message, you may have uploaded a firmware file that is not for your router model or with an incorrect file format. Make sure to download the right firmware file for your router model on the official Asus, Linksys, or Netgear websites, or for Aircove from the ExpressVPN setup page.
The correct file format for different router’s firmwares are:
- Aircove: img
- Asus: trx
- Netgear: chk
- Linksys: img
I’ve “bricked” my router
If you have “bricked” your router (it stops responding after because of a fault in the firmware resetting process), try these steps for the following routers.
- Make sure the router is turned on.
- Hold the reset pin for about ten seconds.
- The LED will flash four times.
- Check if the issue is resolved.
- Turn on the router.
- Keep it on for six to ten seconds.
- Turn off the router.
Repeat this process three more times.