Tarvitsetko VPN:n reitittimellesi?Hanki ExpressVPN nyt
Pidätkö ExpressVPN:stä? Haluatko ilmaisen kuukauden?Suosittele heti ystävälle
This tutorial will show you how to set up ExpressVPN on your D-Link router using L2TP.
Not all ExpressVPN locations may be available for manually configured connections.
The steps below were tested on D-Link DIR-842. Some D-Link models require IP addresses instead of server names for the L2TP manual configuration, while other models (e.g., DSL-225) may not support VPN clients.
If you are unable to follow the steps below because your device interface looks drastically different, contact the ExpressVPN Support Team for assistance.
1. Find your ExpressVPN account credentials
Go to the ExpressVPN setup page. If prompted, enter your ExpressVPN credentials and click Sign In.
Enter the verification code that is sent to your email.
On the right, select L2TP/IPsec.
This will show you your username, password, and a list of server addresses around the world.
Keep this browser window open. You will need this information for the setup later.
2. Configure your D-Link router with the VPN
In your browser’s address bar, enter dlinkrouter.local to access the router admin panel.
Enter your admin password. Click Log In.
In the top menu bar, click Settings > Internet.
Enter the following information:
- My Internet Connection is: Select L2TP.
- L2TP server IP address: Enter the server address you found earlier.
- Username: Enter the username you found earlier.
- Password: Enter the password you found earlier.
- Reconnect Mode: Select On demand.
- Maximum idle time: Select 1.
After the new settings have been saved, you should be connected to ExpressVPN.
To confirm that the VPN connection is working, you can check your IP address.
Disconnect from a VPN server location
To disconnect from a VPN server location, go to Settings > Internet.
For My Internet Connection is, select Dynamic IP (DHCP) > Save.
You are now disconnected from the VPN.